Kíli Project - Boot covers and jacket

This is a long one and it's got a lot of pictures! But, first off, a tiny update on the boot covers: This is how they looked after I finished them:

  

Moving on, I started from scratch again with regards to Kili's jacket because the split leather was simply too thick and the suede finish just didn't work, so instead I found two pairs of leather trousers in a second hand shop and got them for a very decent price. They were so fabulously 80's - early 90's that I had to take a photo of at least one of them:

What's more, one of them had a little colourful surprise:

If this is not the worlds ugliest lining, then I don't know ...


















I took the trousers apart, splitting each into four pieces, which I then shuffled about and stitched back together again to make the basis of the jacket. Once that was done, I needed to finish the trim to be able to continue, so I picked up where I left it last time and started to add the blue material to the edges:
















 I realized quickly that it wouldn't look very good if I simply stitched it on, either by hand or machine, so, instead, I did a second layer of the golden zig-zag seam, only a tiny bit wider so as to fasten the blue material along with it.

Once that bit was done, I hand stitched the material to the backside so that it would look all nice and neat with no visible seams on the front.

When that was done, I started the work of fitting it onto the base of the jacket:












Having carefully pinned it to the leather, I proceeded to stitch it on by hand, and I tell you, this is a job where a thimble, a pair of hobby tongs and a lot of patience is needed!


As you can see on this photo, I decided to attach it so that the trim was sticking a bit outside the leather. This was simply because I hadn't had enough leather to get the exact width I needed, and this added the missing inch.














Because I know it's something Kili cosplayers have been discussing, I thought I'd address the matter of the trim vs. neckline issue by showing how I approached it. I went for the solution of folding the trim in on itself to make the corners, and I feel like it turned out quite nice.




Once the trim was done, there was only the matter of the gambeson sleeves left. From my research, I had found that these were only partially attached, with gaps under the arms for greater flexibility. I'd trimmed the armholes of the jacket basis with plain, black cotton trimming before I started attaching the sleeves.






 Again, thimble, tongs and patience were my friends, but I'd still say this costume is taking it's fair share of blood, sweat and tears. ;)

That's all for now! Next post, I'll be showing you how I made Kili's belt and pictures from the hair test with what was finished of the costume at that point! :)

Kíli Project - Boots & Buckles

Having finished the tunic, I'm working my way trough the bare essentials for the costume, so the obvious next step was the boots. Considering I now have a limited amount of time (and my own costume to fix on the side) before the premiere of The Desolation of Smaug, I'm settling for boot covers, rather than making full boots. I had the leather required, but the boots feature some buckles that I'd be hard pressed to find in any store, as they have a quite particular design, which also is featured on the belt buckle.

So my only decent alternative was to make some from scratch. Using Fimo clay and some steel wire to make them a little bit more resilient, I made six of these, and although I'm not entirely happy with the result (they're far too bulky and chunky), they'll do the job:

When the buckles had cooled down from the oven, I gave them a quick layer of Citadel paint, Ironbreaker, drybrushed on to give a worn look.

While I had the clay out, I figured I might as well try to do the belt buckle as well, and it turned out a lot better:

That's it for now! I'll come back to you with a new update when the boot covers are ready!